LM-60E
6000 WATT
|
![]() |
Major Features
- Honda 11 h.p. GX340 Four Cycle OHV Engine w/ 12 volt DC Alternator to Recharge Battery Made in Japan
- Waterproof Enclosure
- Balanced & Roller Bearing Mounted End to End
- 100 % Power Factor, Suitable for Critical Loads:
All Micro-Electronics, Fire / Rescue & Life Support- One 240 Volt Twist Lock Outlet
- One 120 Volt Twist Lock Outlet
- One 120 Volt Duplex w/ "G.F.I." (Ground Fault Interrupters)
- Electric Key Start & EZ Spin Recoil Pull Start
- Automatic Circuit Breakers
- Doomsday Mission Certified
- Automatic Voltage Regulator Lifetime Warranty
- Solid State Electronic Ignition Lifetime Warranty
- Exceeds U.L. & CSA (Canadian Standards)
- Automatic Idle-Down Package
- Automatic Low Oil Shutdown
- Super Low Tone Muffler
- 5 Gallon Tank Std.
- Prep'd for easy conversion to alternative fuels / nat. gas & lp
- Heavy-Duty Steel Welded Roll Cage
- Rubber Vibration Isolator Mounted
- 36 Month Warranty
- Service Centers Throughout North America and Worldwide
| MODEL | --
WATTS ---- MAX |
- WATTS --- RATED |
VOLTS | AMPS RATED |
HERTZ | PHASE | WIRE | -- -ENGINE ---- -Horsepower |
START |
| LM-60E | 6000 | 5500 | 120/240 | 45.8/22.9 | 60 | 1 | 4 | 11 Honda | Electric |
Page 2. Contact Link at bottom of page.
MODEL |
STARTING METHOD |
NET |
PACKAGED |
NET |
PKG. |
CUBIC |
||||
L |
W |
H |
L |
W |
H |
|||||
| LM-60E | Electric Key Start | 28 | 22 | 24.75 | 28.5 | 22.5 | 25 | 200 | 208 | 10.7 |
< Diagram measurements
for the optional "Super Jumbo" package
| STANDARD FEATURES |
| volt receptacle ------- |
| receptacles --- |
| cleaner---- |
ENGINE FEATURES
MAKE |
............. | Honda GX340 11 h.p. |
| TYPE | ............. | 4 cycle, single cylinder, OHV air cooled, bore 3.2", stroke |
| 2.5", piston displacement 20.6 cubic inches (337cc). | ||
| AIR COOLED | ............. | Flywheel forces air through cylinder block. |
| CRANKSHAFT | ............. | Forged crankshaft with ball bearings on both ends. |
| IGNITION SYSTEM | ............. | Transistorized Magneto. |
| ROTATION | ............. | Counterclockwise (viewed from power takeoff side). |
| CYLINDER | ............. | Diecast aluminum with cast iron sleeve. |
| CYLINDER HEAD | ............. | Aluminum alloy with Stellite valve seats. |
| PISTONS | ............. | Aluminum. |
| PISTON RINGS | ............. | Chrome plated. |
| CONNECTING RODS | ............. | Forged aluminum. |
| VALVES | ............. | Exhaust (Stellite), intake (heat treated). |
| GOVERNOR | ............. | Adjustable mechanical type. |
| FUEL CONSUMPTION | ............. | 5 U.S. gallon capacity standard. |
| .71 gallons per hour fuel consumption @ full load | ||
| .55 gallons per hour fuel consumption @ half load | ||
| .35 gallons per hour fuel consumption @ no load. | ||
| MUFFLER | ............. | Super Low Tone. |
| STARTING | ............. | Electric Start with EZ spin recoil start backup w/ automatic decompressor. |
| OIL PROTECTION | ............. | Automatic low oil engine shutdown. |
HERCULES ELECTRIC GENERATOR SPECIFICATIONS
| TYPE | ............. | Two pole revolving field brushless excitation, self regulated, |
| water proof construction and directly connected to engine. | ||
| EXCITATION | ............. | Self excitation provided by an auxiliary phase closed on a capacitor. |
| DIODES | ............. | Silicon rectifier, hermetically sealed, 1000 volts with surge suppressors (varister). |
| POWER FACTOR | ............. | Single phase rated at 100 % "Unity" power factor. |
| FREQUENCY REGULATION | ............. | Less than 1 Hz (+ / - 1% running loads) 4 Hz (5%), no load to rated load. |
| DISTORTION | ............. | Extremely low harmonic distortion suitable for all electronic applications. |
| BEARING | ............. | Double shielded and sealed ball bearings. |
| COOLING | ............. | High volume direct drive centrifugal fan forces air through the generator, |
| discharging it at engine end. | ||
| RADIO FREQUENCY INTERFERENCE SUPPRESSION | ............. | Totally brushless design exceeds civilian and military applications. |
| INSULATION | ............. | Class H (Stator & Rotor) per NEMA MG1-1.65, epoxy varnish impregnation. |
| STATOR | ............. | Steel laminations with all copper double insulation wire, inserted into slots. |
| Epoxy impregnation with load taken directly from leads. | ||
| ROTOR | ............. | Unique "Skewed Rotor Winding Design." Steel laminations pressed on tapered |
| steel shaft with double insulated wire inserted into insulation slots, wedged in with | ||
| epoxy impregnation. Dynamically balanced. Short circuit capacity - 300% | ||
| VOLTAGE REGULATION | ............. | + / - 1% running loads ( + / - 5% no load to load ). |
| All units are manufactured to the highest engineering standards consistent with the industry. ELECTRIC GENERATOR SELECTIONS: When selecting an electric generator be sure that the unit takes care of present total requirements and your anticipated needs. Motor loads require 3 to 4 times the wattage (or amperage) ratings on nameplate. RATINGS: Ratings apply to altitudes up 1000-feet, standard cooling normal ambients and gasoline fuel. Reduce ratings 3 1/2% for each 1,000 feet above sea level and 1% for each 10 degrees Fahrenheit rise above 60 degrees Fahrenheit. Please refer to the Safety link below. |
IMPORTANT: THE EQUIPMENT OFFERED AT THIS SITE IS NOT DEPARTMENT STORE GRADE, THESE ARE THE HIGHEST QUALITY HEAVY DUTY COMMERCIAL / INDUSTRIAL GRADE UNITS. IF YOU ARE LOOKING FOR THE LEAST EXPENSIVE, LOWER QUALITY COMPRESSORS AND/OR GENERATORS PLEASE GO TO YOUR LOCAL MASS MERCHANDISING WAREHOUSE. YOU CAN ALSO ORDER LOWER GRADE EQUIPMENT FROM A VARIETY OF NATIONAL MAGAZINES TO ACHIEVE RESTRICTIVE PRICE GOALS.
| SUPPORT NET METERING LAWS IN YOUR STATE!!!
|
http://adoptaplatoon.com
http://www.uso.org "until
everyone comes home"
.